Turning The Receiver On - Canon GP-E2 Mode D'emploi

Turning the Receiver On

<ON> Position
The receiver functions in this position only with EOS DIGITAL
cameras that display [GPS device settings] in the menu.
Shots taken while the receiver is attached to the camera are
geotagged, adding location information (latitude, longitude,
elevation, and shooting time) to images.
Images can also be tagged with the shooting direction, using the
receiver's digital compass.
<LOG> Position
With the switch in this position, the receiver keeps a record of
location information along the route traveled.
The route can be viewed on a virtual map. Logs can also be used to
geotag images at a later time.
The images that can be geotagged after shooting with logging
information are JPEG and RAW images (file extension: CR2) shot
with EOS DIGITAL cameras.
Movie files can also be geotagged this way at a later time, when using
cameras that display [GPS device settings] in the menu (except with
the EOS 7D).
When the receiver is attached or connected to a camera that
displays the [GPS device settings] menu item, the receiver will
geotag images as you shoot, and periodically log location
information. Images can also be tagged with the shooting direction.
* EOS 7D does not support tagging of the shooting direction.
Checking the battery level
Check the battery level on the <BATT.>
indicator.
Slow blinking : Level OK
Fast blinking : Little power left
Off : Replace battery
11