Installation; Maintenance & Servicing; Environmental Conditions; Equipment Disposal - OHAUS VXMTAL Manuel D'instructions

i
nStallation
Upon receiving the Ohaus Multi-Tube Vortexer, check to ensure that no damage has
occurred in shipment. It is important that any damage that occurred in transport is
detected at the time of unpacking. If you do find such damage the carrier must be noti-
fied immediately.
After unpacking, place the Multi-Tube Vortexer on a level bench or table, away from
explosive vapors. Ensure that the surface on which the unit is placed will withstand
typical heat produced by the unit and place the unit a minimum of six (6) inches from
vertical surfaces. Always place the unit on a sturdy work surface.
The Multi-Tube Vortexer is supplied with a power cord that is inserted into the IEC
connector on the back of the unit first, then it can be plugged into a properly grounded
outlet. The 120V unit plugs into a 120 volt, 50/60 Hz source. The 230V unit plugs into
a 230 volt, 50/60 Hz source.
m & S
aintenance ervicing
The Multi-Tube Vortexer is built for long, trouble-free, dependable service. No lubrication
or other technical user maintenance is required. It needs no user maintenance beyond
keeping the surfaces clean.
The unit should be given the care normally required for any electrical appliance. Avoid
wetting or unnecessary exposure to fumes. Spills should be removed promptly. DO NOT
use a cleaning agent or solvent on the front panel which is abrasive or harmful to plastics, nor
one which is flammable. Always ensure the power is disconnected from the unit prior to any
cleaning. If the unit ever requires service, contact your Ohaus representative.
Stainless Steel Units: routine cleaning can be accomplished by using warm water and a
cloth. Wipe in the directions of the polish lines for the best results. For best cleaning results
always use a non-abrasive cloth, 100% cotton or microfiber recommended for low residual
lint. Dry with a similar cloth to prevent water spots. For more stubborn stains, try using the
same process as above with a mild detergent soap. Finger prints can be removed by wiping
the stainless steel housing with a cloth dampened with common household glass cleaning
products. Decontamination of the exterior can be accomplished by using routing biocides or
alcohol applied with a cloth or wipe. Do not saturate.
i u
ntended Se
Multi-Tube Vortex Mixers are intended for general laboratory use.
e c
nvironmental onditionS
Operating Conditions: Indoor use only.
Temperature: 4 to 40°C (39 to 104°F)
Humidity: 20% to 85% relative humidity, non-condensing
Altitude: 0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: 20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
e d
quiPment iSPoSal
This equipment must not be disposed of with unsorted waste. It is your responsibility
to correctly dispose of the equipment at life-cycle-end by handing it over to an
authorized facility for separate collection and recycling. It is also your responsibility
to decontaminate the equipment in case of biological, chemical and/or
radiological contamination, so as to protect the persons involved in the
disposal and recycling of the equipment from health hazards.
For more information about where you can drop off your waste of
equipment, please contact your local dealer from whom you originally
purchased this equipment. By doing so, you will help to conserve natural
and environmental resources and you will ensure that your equipment is recycled in a
manner that protects human health.
EN
2