RealFlame 5020E Mode D'emploi page 9

Operation
Read all instructions before use.
Check that the replace outlet grill is not covered or obstructed in anyway, and make sure the power to the unit is switched on.
NOTE: When the heat function is used for the rst time, a slight odor may be present. This is normal and should not occur again unless
the heater is not used for an extended period of time.
Using the Control Panel
The control panel is located behind the door of the stove.
Main Power Switch: The power switch supplies
power to all of the functions of the replace. This
switch must be in the ON position for any functions
to work.
Flame E ect: Toggle the power switch ON. The
power indicator light will glow. The ame e ect will
be visible through the front glass.
Temperature Knob: Toggle the temperature switch
ON. The temperature control knob regulates the
temperature level of the room. The further the knob
is rotated clockwise, the higher the temperature
setting. Turning the knob counter-clockwise, will
lower the temperature setting. There are 4 gears for
the temperature setting (20°C/68°F, 25°C/77°F,
30°C/86°F, 35°C/95°F). Use this function to help
regulate the ambient temperature level.
Temperature Limiting Control: This replace is
equipped with a temperature limiting control.
Should the replace reach an unsafe temperature,
the heater will automatically turn o . To reset: unplug
the power cord from the outlet. Wait 5 minutes. With
the power switch in the OFF position, plug the power
cord back into the outlet.
Temperature Control Power and heater ON/OFF