RealFlame 5020E Mode D'emploi page 10

Maintenance
Under no circumstances should this product be used with broken glass.
Do not strike or slam the glass.
Do not use abrasive cleaners to clean the glass.
This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done by a quali ed service person.
Always disconnect the replace from the main power supply and allow it to cool before any servicing operation.
The motors used on the fan heater and ame blower are pre-lubricated for extended bearing life and require no further
lubrication. However, periodic cleaning/vacuuming of the replace around the air intake and exhaust, as well as the fan heater is
recommended. For heavy or continuous use, periodic cleaning must be done more frequently. If the heater blows alternating
cold and warm air, check the fan for free movement and for debris restricting air ow. If the fan does not move freely, the unit
must be turned o and the fan replaced immediately in order to prevent further damage to the replace.
Always turn the replace OFF and unplug the power cord from the outlet before cleaning. Use a vacuum or duster to remove
dust and dirt from the heater and vent areas. To maintain the nish, clean with a soft, slightly damp cloth and bu with a dry
cloth. Never use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.