Poulan Pro PPBV25 Manuel D'instructions page 6

4. Align the tabs on the inside of the vacuum in-
let with the slots on the upper vacuum tube.
Tab
Slot
5. Push the upper vacuum tube into the vac-
uum inlet. Turn the tube counterclockwise
until a click is felt to secure the tube to the
blower unit.
6. Align slanted end of lower vacuum tube as
shown. Firmly push lower vacuum tube
into upper vacuum tube.
Slanted end of
lower vacuum tube
7. Permanently assemble the two tubes to-
gether with the supplied screw.
Lower
Vacuum
Tube
Upper
Vacuum
Tube
-- 6 --
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
WARNING:
While blowing debris, hold
the unit with the muffler side facing away from
your body and clothes (see OPERATING
POSITION).
1. Remove the elbow tube and vacuum bag
by turning the bolt counterclockwise to
loosen the elbow tube.
2. Remove the vacuum tubes by turning the
tubes clockwise.
3. Close the vacuum inlet cover and make
sure it is latched closed.
4. Reinstall the blower tubes (see BLOWER
TUBE ASSEMBLY).
VACUUM BAG SHOULDER STRAP
ADJUSTMENT
WARNING:
hold the unit with the muffler side facing away
from your body and clothes (see OPERATING
POSITION).
1. Pass the shoulder strap over your head
and onto your left shoulder.
2. Extend your right arm toward the rear of
the vacuum bag.
3. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
4. Make sure air flows freely from the elbow
tube into bag. If bag is kinked, the unit will
not operate properly.
While vacuuming debris,