Fax +32 2 359 95 50
GETTING STARTED
Insert the plug into the wall socket, and the two LED function lights in the thermostat
buttons (3 and 9) will illuminate Blue. This indicates that the device is receiving power, and
ready for use.
Turn the Heat on by turning the progressive thermostat (3 and 9) clockwise. The LED
function light (3 and 9) will illuminate Red.
The grill plate (11) has two separate heating zones. These can be switched on and
adjusted separately with the respective thermostat controller below.
Preheat the unit for about 10 minutes at maximum power, then set the progressive
thermostat to the desired temperature level.
During operation, the LED function lights will alternate between Red and Blue illumination.
This is totally normal as the thermostat automatically regulates throughout the heating
process. So, when the desired temperature is reached, the LED function lights will first
illuminate Blue. If they switch back to Red, the device is heating up again, before returning
to Blue once the desired temperature is reached. This is the normal cycle of the
thermostat once the desired temperature is reached.
Open the lid (5).
Place the food on the grill plate (11).
The grilling times are always different depend on the type of food being cooked and the
individual weight of each item.
Always use the handle (4) to open and close the lid.
DRIP TRAY
The drip tray (6) collects any grease emitting from foods during the grilling process. Please
make sure that the area where the Drip Tray is inserted into the Electric barbecue housing
(6) is not blocked.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don't change the page numbering. Keep the language
integrity.
9
Assembly page 9/40
TKG EBBQ 1002 L- 181130