Publicité
Les langues disponibles
Les langues disponibles
1b.
INSTALLATION OPTION 2: Concrete/Brick Wall Installation
1). Attach the Wall Plate Template (BB) to the wall at the desired installation location.
2). Ensure the Wall Plate Template (BB) horizontal alignment is verified with a bubble level
and mark 6 lag bolt installation locations on the stencil and the wall.
3). Use a 3/8" (10 mm) drill bit to drill a pilot hole on the wall with a depth of at least 2.6"
(65mm). Please note, failure to drill pilot holes may result in the lag bolt heads snapping
during installation.
Insert 6 x Wall Anchors (I) into holes. Secure the Wall Plate to the wall
with 6 x Lag Bolts (H) and 6 x Washers (H).
2.
This full motion TV wall mount comes with a sliding mechanism that allows the arms and the
TV to slide horizontally left or right for up to 15.7 inches, while the wall plate is stationary on
the wall. This feature allows the TV to be placed at an optimal position, regardless of the
position of the wall studs. The mount will ship with the locking bars installed in place at their
center position. If the sliding function will be used, take off the locking plates by removing the
bolts that hold them in place. Place the top locking bar at the desired position to fix the left
slide limit of the arms and place the bottom bar at the desired position to fix the right side
limit of the arms. The raised metal piece at the end of the locking bars limit the slide of the
arms. Ensure the locking bars are oriented correctly to ensure both the left and right side
locking bars correctly limit the slide. Ensure both of the bolts are tightened at each locking
bar's position to prevent the arms from sliding off the wall plate. WARNING: FAILURE TO
INSTALL THE LOCKING BARS ADEQUATELY MAY RESULT IN THE ARMS AND THE TV
FROM SLIDING OFF THE WALL PLATE.
Concre te
wall
3
16" - 24"
8
"
wall
m)
Wood stud
(41 cm- 61c
Masonry
Bit
Hammer
Requir ed
Tools
7
"
32
mm )
2.56 " (65
Wood Bit
3/8"
(10 mm )
Stud Finder
TEMPLA
TE
Drill
Level
Pencil
mm )
2.56 " (65
7/32 "
HOLE S
)
DRILL ING
(5.5 mm
BEFO RE
each hole
to
Tape over
nt of dust
the amou
minim ize
TEMPLA
TE
65mm
(2.6")
13mm
Publicité
