Advance Micromatic 13E Instructions D'utilisation page 7

WARNING!
– Do not use the machine as a means of transport.
–
Do not use the machine on slopes with a gradient exceeding the specifications.
–
Do not allow the brush/pad to operate while the machine is stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a water one.
– Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
flow.
– Do not remove or modify the plates affixed to the machine.
– This machine cannot be used on roads or public streets.
– Pay attention during machine transportation when temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously damage the machine.
– Use the brushes and pads supplied with the machine and those specified in the Instructions for Use
Manual. Using other brushes or pads could reduce safety.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary,
request assistance from the authorized personnel or from an authorized Service Center.
– If the machine
• does not work properly
• is damaged
• has water or foam leaks
• has been left outdoors exposed to bad weather conditions
• is wet or has been dropped into water turn it off immediately and contact the Advance Service Center or a
qualified technician.
–
If parts must be replaced, require ORIGINAL spare parts from an Authorized Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
this Manual, must be performed by the authorized personnel or by an authorized Service Center.
– Carefully read all the instructions before performing any maintenance/repair procedure.
– Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (electronic
components, etc.), which are subject to standards that require disposal in special centers (see the
Scrapping chapter).
INSTRUCTIONS FOR USE
Micromatic™ 13E 9097508000(1)2008-03
ENGLISH
5