Eliminating Flickering Or Blurring - Sony CPD-L133 Mode D'emploi

Eliminating Flickering or Blurring

If a part of the screen is flickering or blurring, press the
AUTO button. If this operation does not work, adjust the
Pitch and Phase as follows.
Once the pitch and phase are adjusted, they will be stored in
memory for the current input signal.
1
Load the Utility Disk (page 10).
2
Press the MENU button.
The MENU OSD appears.
MENU
3
Press the ø /‡ buttons to select PITCH, and press the
MENU button again.
The PITCH OSD appears.
MENU
4
Press the +/– buttons until the screen color becomes
uniform.
If you are using the Utility Disk, adjust so that the
vertical stripes disappear.
5
Press the MENU button.
The MENU OSD appears.
If horizontal stripes are observed over the entire screen,
adjust the Phase in the next step.
6
7
MENU OK MENU
EXIT
PHASE
PITCH
CENTER
The OSD automatically disappears after about 30 seconds.
ZOOM
COLOR
To close the OSD, press the MENU button again.
LANGUAGE
OPTION
To turn off the test pattern, click [END] on the screen.
PITCH
1328
Getting Started
Customizing Your Monitor
Press the ø /‡ buttons to select PHASE, and press the
MENU button again.
The PHASE OSD appears.
MENU
Press the +/– buttons until the screen color becomes
uniform.
If you are using the Utility Disk, adjust until the
horizontal stripes are at a minimum.
PHASE
26
EN
F
D
ES
I
11