ECOVACS ROBOTICS DEEBOT Manuel De L'utilisateur page 12

3. Operating and Programming
4 Charge DEEBOT 7
Place DEEBOT 7 on the Charging Dock making
sure the Charging Contacts on DEEBOT 7 and
the Charging Dock Pins make a connection.
Charge DEEBOT 7 for at least 12 hours before
the first use.
*
The Status Light Indicators on the top of the robot and the Battery Display on the robot's
Control Panel Screen blink when DEEBOT 7 is charging and go off when DEEBOT 7 is fully
charged.
*
Remove DEEBOT 7's batteries if the robot will not be used for a long time. In case of battery
leakage, please remove the battery and wipe the battery slot clean while wearing protective
gloves.
*
If batteries are fully discharged or not used for a long time, their capacity may decrease and
need to be reactivated.
*
To reactivate the batteries: Place the robot on the Charging Dock by hand, remove after charging
for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
*
DEEBOT 7 uses long life Ni-MH batteries that do not require frequent replacement.
To replace the batteries, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Cover Screws, remove Battery Covers.
b. Remove the batteries and disconnect the fasteners.
c. Connect the corresponding positive and negative fasteners on the new batteries. Insert
the new batteries, reassemble the Battery Covers and screw in the Battery Cover Screws.
5 Start
Press on DEEBOT 7 or AUTO Mode Button on the Remote Control. DEEBOT 7 starts to
work immediately in AUTO Cleaning Mode.
*
To choose another Cleaning Mode, please refer to section 3.3 Cleaning Mode Selection for
details.
10
EN