Publicité
Les langues disponibles
Les langues disponibles
Fig. K
7
Fig. L
15
Proper Hand Position (Fig. A, M)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires the left hand on the front
handle (
13
) , with the right hand on the rear handle (
Fig. M
Operating the Chain Saw (Fig. A, N–O)
WARNING: Read and understand all instructions.
Failure to follow all instructions listed below
may result in electric shock, fire and/or serious
personal injury.
•
Guard Against Kickback which can result in severe
injury or death. See Important Safety Instructions
guard Against Kickback, to avoid the risk
of kickback.
•
Do not overreach. Do not cut above chest height.
Make sure your footing is firm. Keep feet apart.
Divide your weight evenly on both feet.
•
Use a firm grip with your left hand on the front
handle (
13
) and your right hand on the rear
handle (
12
) so that your body is to the left of the
guide bar.
14
On / Off Switch
Always be sure of your footing and grip the chain saw firmly
with both hands with the thumb and fingers encircling
both handles.
This tool is equipped with a variable speed trigger switch.
To turn the unit on, ensure chain brake is not engaged. Push
down on the the lock off lever (
squeeze the trigger switch (
may release the lock off lever. The farther you depress the
12
) .
trigger, the faster it will operate.
In order to keep the unit running you must continue to
squeeze the trigger. To turn the unit off, release the trigger.
nOTE: If too much force is applied while making a cut the
saw will turn off. To restart saw, you must release the lock off
lever (
Begin your cut again this time with less force. Allow the saw
to cut at its own pace.
Fig. N
Setting The Chain Brake
Your chain saw is equipped with a motor chain braking
system which will stop the chain quickly in case of kickback.
•
•
•
Do not hold chain saw by front hand guard/
chain brake (
3
) . Keep elbow of left arm locked so
that left arm is straight to withstand a kickback.
WARNING: Never use a cross-handed grip (left
hand on the rear handle and right hand on the
front handle).
WARNING: Never allow any part of your body to
be in line with the guide bar (
chain saw.
•
Never operate while in a tree, in any awkward
position or on a ladder or other unstable surface.
You may lose control of saw causing severe injury.
•
Keep the chain saw running at full speed the entire
time you are cutting.
•
Allow the chain to cut for you. Exert only light
pressure. Do not put pressure on chain saw at
end of cut.
WARNING: When not in use always have the
chain brake engaged and battery removed.
1
2
) and the trigger switch (
WARNING: Never attempt to lock a switch in the
ON position.
2
1
Remove the battery from the tool.
To engage the chain brake, push the chain brake / front
hand guard (
) forward until it clicks into place.
3
English
4
) when operating the
2
) , shown in Figure N, and
) . Once the unit is running, you
1
) before the saw will restart.
13
Publicité
