emerio MC-121884.1 Mode D'emploi page 5

MC-121884.1
GENERAL DESCRIPTION
1. Motor unit
2. Lid
3. Jar
4. Non-slip mat
5. Turbo button
6. Stainless steel blade
7. Blade protection
BEFORE USE
Remove the appliance from the packaging.
Take care when handling sharp blades. Remove the blade protection from the blades.
Clean the appliance as described in section "cleaning and maintenance".
USE
1. Attach the blade on to blade support in the jar and pour in the food to be chopped.
Hard food must be cut into small pieces (about 2cm). Otherwise, the motor may block. Press "TURBO" for
processing.
2. Attach the removable lid on top of the jar and then the motor unit, plug the appliance in. Press down on the
motor unit, and the multi chopper starts up immediately.
NOTE: After put the food in the jar, if the blades cannot speed up in a few seconds, please unplug the unit and
take out part of food, then continue.
3. After use, unplug the appliance and wait unit the blade stops completely. Remove the motor unit, the
removable lid and the blade.
Always make sure the motor unit is in place; otherwise the unit will not function.
Take note of the following table:
Foodstuff
Fig + honey
Vegetables (cut into small
pieces of 20x20x50mm)
Meat (cut into small pieces
of 20x20x50mm)
Liquid
Do not operate for more than 1 minute at a time. Stop and cool for 2 minutes then resume.
Please make sure the appliance rest more than 2 minutes between any two operations. After working 3 cycles, the
unit has to stop 15 minutes to wait the main engine to cool down.
This product cannot chop hard things, such as meat with bones, soya bean, pepper, coffee bean, ice cubes and
freezing food.
Filling quantity Processing time
≤270g 15 seconds
≤200g 15 seconds
≤200g 30 seconds
≤200ml 1 minute
Speed
Turbo
Normal
Turbo
Turbo
- 4 -
EN