Icy Dock MB992SKR-B Mode D'emploi page 5

7
RAID Monitoring Software
The RAID monitoring software supports both Windows and Mac OS,
please visit http://icydock.com and download the software from the
product page, located at Support & Download section:
a. Please make sure the device is connected to the computer
and powered on then double click
b. Different RAID modes will display differently (See below)
RAID and Disk Information
Controller 1
RAID Information
P0: H/W RAID 0
RAID Level RAID 0
M0: ST3320620AS
Status Normal
M1: ST3320620AS
Capacity 596.06 GB
Plugged Member(s) M0, M1
M0(P0)
Disk 1
298.03 GB
298.03 GB
Disk 2 M1(P0)
298.03 GB 298.03 GB
RAID 0
RAID and Disk Information
Controller 1
RAID Information
P0: H/W LARGE
RAID Level LARGE
M0: ST3320620A
Status Normal
M1: ST3320620A
Capacity 596.06 GB
Plugged Member(s) M0, M1
Disk 1 M0(P0)
298.03 GB 298.03 GB
Disk 2 M1(P0)
298.03 GB 298.03 GB
BIG
English
to launch.
ICY DOCK HW
RAID Manager
RAID and Disk Information
Controller 1
RAID Information
P0: H/W RAID 1
RAID Level RAID 1
M0: ST3320620A
Status Normal
M1: ST3320620A
Capacity 298.03 GB
Plugged Member(s) M0, M1
Disk 1 M0(P0)
298.03 GB 298.03 GB
M1(P0)
Disk 2
298.03 GB 298.03 GB
RAID 1
RAID and Disk Information
Controller 1 Controller Information
[427491329]
P0: ST3320620AS
ST3320620AS 298.06 GB
P1: ST3320620AS
ST3320620AS 298.06 GB
Disk 1 Unreleased
298.06 GB 298.06 GB
Unreleased
Disk 2
298.06 GB
298.06 GB
JBOD
7
English
8
Important Info
1. While creating or changing RAID mode, the chipset will
automatically erase any data previously stored in the drives.
Please be sure to backup any data before setting up RAID modes
to prevent data loss.
2. It is recommended to use identical brand new hard drives for any
RAID array, if you are using hard drives that have been used in a
RAID before, you must first remove the previous data and restore
the hard drive to factory settings in order to prevent any RAID
mode failure.
3. You cannot use the RAID array created by this device with
different RAID cage. The IC chipset and firmware must be the
same otherwise it may cause data loss. If the product
malfunctions, please contact our customer support.
4. Due to different drive specifications for the drive access signal,
some drives may not support the access LED. If the LED does not
function properly, but able to read and write to the drive, it would be
the drive specifications are different . If the LED does not function,
and the drive cannot be read or written to, please contact us.
5. It is recommend to use ERC (Error Recovery Control) supported
hard drives to ensure best RAID performance.
For more product information, please visit http://www.icydock.com
8