Publicité
Les langues disponibles
Les langues disponibles
3-5
Remove the plastic bar with a screwdriver
and keep the 2 removed flat head screws
for 2.5" drives installation later.
3-7
M3*4 flat head screw
Please use the included M3*4 flat head screws
with the two M3*4 flat head screws removed
earlier from the plastic bar to install 2.5"drives.
3-9
Once the drive installations are completed, set your desired RAID mode.
(Note: default is set to JBOD mode, if you wish to change RAID mode, please refer to
section 4 - Using the RAID Mode). Install the device to the 3.5" front device bay with the
included M3*4 screws, connect both SATA 7 pin and 15 pin power cable to your system.
English
3-6
The tray accommodates 2.5" drives
up to 9.5 mm height.
3-8
3-10
Locked
3
English
4
Using the RAID Mode
The device is factory preset to JBOD mode (system will recognize the
two drives as two individual volumes). If you wish to change the
RAID mode, please follow the steps below:
1. Make sure to back up the data in the drives and power off the system.
2. Select the preferred RAID mode by using the RAID switch located
on the back of the device.
3.
Restart your system to complete RAID change.
4. Format the RAID volume you just created, and recreate new
drive partition(s).
Caution: Changing RAID settings may permanently erase any exisiting data on the
hard drive and cannot be restored. If there are existing data on the hard
drive, please back up the data first before RAID setup.
5
LED Status Indicators
RAID Status
Empty bay
HDD(s) in bay
Drive activity
LED indicators
HDD access
HDD fail
RAID rebuilding
Rebuild LED
indicator
RAID rebuild completed
4
LED Indicators
No light
Solid green LED
Flashing green LED
Solid red LED
Flashing amber LED
Lights off
Publicité
