Bushnell IMAGE VIEW 111545 Mode D'emploi page 13

sHootinG Videos
shooting videos (setting/Using video Mode)
To switch from still photo to video mode, hold the SNAP button down for 2-3 seconds, until a beep is heard.
The video mode icon (a frame of movie film) will appear at the top left corner of the LCD. You are now in
Video Mode. Press the snap button on the remote cable or scope twice to start recording a new video clip,
and press it once again to stop recording. The recording time is limited only by the amount of internal or
card memory currently available. You may record a single long video until you run out of memory or multiple
shorter videos by stopping and starting recording whenever you wish by pressing snap. The counter at the
bottom of the display shows the time elapsed since the recording was started.
Videos are recorded as ".avi" format files, with VGA resolution (640x480 pixels per frame, 20 fps rate). Note that
the Size and Quality settings in the Capture menu do not affect videos, only still photos.
Press the ok button if you wish to check a video after you shoot it. Press the snap button to begin playback,
press it again to pause playback (the display will indicate "AVI PAUSE"). During playback, the counter at the top
of the LCD displays time elapsed since the start of the video clip. Press the Down arrow key to review previous
video or still photo files. When you are ready to return to the live preview display to shoot more videos (or
stills), press the ok button.
13