Using The Dab+ Radio; Setting The Dab+ Stations - Kenwood CR-M10DAB Notice D'emploi

Setting the alarm
2 different alarm times can be set in the CR-M10DAB. The alarm can also be programmed for the follow-
ing time blocks: "Daily" / "Once" / "Weekends" / "Weekdays".
To set the alarm time, please proceed as follows:
1. Switch the radio on and, using the <SOURCE> button, select the source FM.
2. Press the <MENU> button, then, using <TUNE+/->, select the "System" menu and then press
the "VOL" control.
3. Using the <TUNE+-> buttons, select the "Alarm" menu and then confirm.
4. "Alarm 1 setup" will be displayed. You can now adjust the alarm time 1 or, using the
<TUNE+/-> button, change to alarm time 2 ("Alarm 2 setup").
5. After confirming using "VOL", please carry out the following steps:
• Setting hours and minutes (select numbers using <TUNE+/->, advance with "VOL").
• Setting the alarm duration (select 15, 30, 45, 60, 90 minutes using <TUNE+/->, advance with "VOL")
• Select the source Buzzer, DAB or FM using <TUNE+/->, advance with "VOL".
• Select "Last listened" or other storage location using <TUNE+/-> , advance with "VOL").
This selection will only appear, if FM or DAB was selected as a source.
• Select "Daily" / "Once" / "Weekends" / "Workdays" using <TUNE+/->, advance with "VOL").
• Select switch-on volume using <TUNE+/->, advance with "VOL").
• Select Alarm "On" or "Off" using <TUNE+/->, advance with "VOL"). The alarm time is now
saved and an alarm symbol appears on the top left of the display.
To set the 2 alarm time, proceed similarly. To delete a set alarm, select the setting "Alarm off" in
nd
the last step.
The alarm comes on at the set time for the set duration. If you want to end the alarm, please press
the "Standby" button.

Using the DAB+ radio

Press the <SOURCE> button on the radio until "DAB" appears in the display.

Setting the DAB+ stations

A station scan was carried out when the device was put into operation. The stations detected in the process
are stored alphabetically in the channel list.
Starting the automatic station scan again:
• Press the <MENU> button to bring up the DAB menu.
"Full scan" shows on the display. Start the scan by using the "VOL" button.
• During the scan, the display shows the number of stations found so far.
• If no stations are found during the scan, then "No DAB stations" appears on the display after approx.
2 seconds and afterwards changes to the display "Full scan". Then please test that the antenna is
correctly oriented or try to find a different location 1 for the device to obtain a better reception.
10