Prior To Start-Up; Connecting - Kenwood CR-M10DAB Notice D'emploi

Prior to start-up

Unpacking
Carefully unpack the device and ensure that all accessory parts are present:
Operating instructions
Insert batteries (not supplied)
• Insert 4 R6 / AA / Mignon batteries into the radio, ensuring
the correct polarity (+ and -).
• Power supply via the batteries will be shut off if
power is being supplied via the plug-in power supply unit.
• Batteries will wear out sooner if they are used in cold
surroundings.

Connecting

• Carefully unpack the device and ensure that all accessory parts are present:
• Connect the plug-in power supply unit to the radio and to the mains socket.
DAB+ / FM telescopic antenna
1. Carefully release the antenna from the lower part of the housing.
2. Rotate the antenna upwards and pull all elements out completely.
3. Align the antenna so that the best reception is obtained.
Using for the first time
When the device is used for the first time, an automatic DAB+ station scan is started. Please wait until this
process has completely finished. For more information, please refer to the section "Use of the DAB+ radio".
6
Plug-in power supply unit