Setting The Display Lighting; Setting To Sleep Timer - Kenwood CR-M10DAB Notice D'emploi

Setting the display lighting

The display lighting can be set in 3 brightness levels. The following settings can be performed in the
"Backlight" menu:
"On level": Display brightness when the radio is switched on.
Options: "High" / "Medium" / "Low"
"Dim level": Brightness setting for operation and standby.
Options: "High" / "Medium" / "Low"
"Timeout": Time until the display is adjusted to the "Dim setting" lighting level.
Options: "On / 10 sec / 20 sec / 30 sec / 45 sec / 60 sec / 90 sec / 120 sec / 180 sec"
"On" means that the radio always stays at the "On level" setting brightness level.
To set, please proceed as follows:
1. Switch the radio on and, using the <SOURCE> button, select the source FM.
2. Press the <MENU> button, then, using <TUNE+/->, select the "System" menu and then press
the "VOL" control.
3. Using the <TUNE+-> buttons, select the "Backlight" menu and then confirm.
4. Select the functions in the individual menus "On level" / "Dim level" /
"Time out" and confirm using the <VOL> button.
Setting the sleep timer
The sleep timer is used to switch off the radio after a preset period. To set, please proceed as follows:
1. Switch the radio on and, using the <SOURCE> button, select the source FM.
2. Press the <MENU> button, then, using <TUNE+/->, select the "System" menu and then press
the "VOL" control.
3. Using the <TUNE+-> buttons, select the "Sleep" menu and then confirm.
4. Please select the following options in the following menu: "Off"/"15, 30, 45, 60, 90 minutes".
Confirm with the <VOL> button.
5. In the display in the central line, on the right, the information "Sxx" appears, where "xx" shows
the remaining time until the radio switches off. If you want to deactivate the sleep timer, please
select the "Off" time setting.
9