Troubleshooting - Hart HGHST01 20V Manuel De L'opérateur

TROUBLESHOOTING

PROBLEM
Line will not advance when using
the auto-feed head
Grass wraps around boom
housing and string head
Motor fails to start when switch
trigger is depressed
POSSIBLE CAUSE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground level.
Battery is not secure.
Battery is not charged.
12 – English
SOLUTION
Lubricate with silicone spray.
Install more line. Refer to Line Replace-
ment earlier in this manual.
Pull line while pressing button.
Remove line from spool and rewind.
Refer to Line Replacement earlier in
this manual.
Cut tall grass from the top down to pre-
vent wrapping.
To secure the battery pack, make sure
the latches on each side of the battery
pack snap into place.
Charge the battery pack according to the
instructions included with your model.