Operation - Hart HGHST01 20V Manuel De L'opérateur

ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the product or unplug from the power source when
assembling parts.
ATTACHING GRASS DEFLECTOR
See Figures 2 - 3.
WARNING:
The line cut-off blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.

OPERATION

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
 Remove the bag with screws from the grass deflector.
 Fit the grass deflector onto the trimmer head.
 Line up the screw holes in the grass deflector with the
holes in the trimmer head.
 Install supplied screws and tighten by turning clockwise
with a Phillips screwdriver.
INSTALLING THE FRONT HANDLE
See Figure 4.
 Loosen and remove the wing nut and bolt from the
handle.
 Install the handle on the power head shaft at the location
indicated by the label on the shaft.
 Adjust handle up or down, if necessary, to desired
operating position.
 Reinstall the bolt and wing nut. Tighten wing nut to
secure.
NOTICE:
This product is designed to be powered by either an
20 V battery pack (DC mode) or by electric power (AC
mode). The power mode is selected by sliding the power
selection door to the desired power source and either
installing an approved battery pack or extension cord as
described in this manual.
APPLICATIONS
You may use this product for the purpose listed below:
 Trimming grass and weeds from around porches, fences,
and decks.
WARNING:
Always remove the battery pack or disconnect the
tool from the power supply and keep hands clear of
the lock-out button and switch trigger when carrying,
transporting, assembling parts, making adjustments,
cleaning, or when not in use. Following these instructions
will prevent accidental starting that could cause serious
personal injury.
8 – English