Topcom HB 10M00 Manuel D'utilisateur page 4

4 CHANGING THE BATTERY
If you are not confident with electronics, let the battery be changed by a
professional. Do not open the watch yourself.
4.1 WATCH & CHEST BELT
THE WATCH AND CHEST BELT HAVE ALREADY A
BATTERY INSIDE, so no need to place this battery when you
just bought it. To turn the watch on see "5 Power save mode".
1.Turn the battery cover with
a coin counterclockwise
until the arrow is pointing to
the arrow.
2.Turn the cover gently further
to pop it out.
3.Put the battery cover aside.
4.Remove the empty battery.
5.Insert a new CR2032 bat-
tery, the (+) side of the bat-
tery must touch the 'L'-
shaped metal contact.
6.Make sure the sealing rubber O-ring is placed correctly in its slot before
the battery cover is closed.
7.Put the battery cover back with the arrow on the cover pointing to the
arrow, and then press the cover down gently until it is on the same level
as the surface.
8.Turn the cover with a coin clockwise until the arrow is pointing to the dot.
4.2 GPS POD
The GPS pod has a build-in battery which can't be removed/replaced
unless you send it out for repair. Please follow the repair instructions if the
battery of your GPS pod doesn't work anymore.
5 POWER SAVE MODE
This watch is sold with a power save function so that the battery can last
longer. To turn this watch (display) on, press any key.
To activate the power save mode press the LAP/RESET key [ ] for
5 seconds in time mode.
4
TOPCOM HB 10M00