Nolangroup N-Com MCS III R Serie Mode D'emploi page 13

3.3. Removing the MCS III system from the helmet
Proceed as follows to remove the MCS III system from the helmet:
 Remove the cheek padding and the shell gasket.
 Unhook the right and the left clips from the shell, levering upward using a flat head screw (or a
similar tool), as shown in figure 18.
 Completely remove the MCS III system from helmet using a flat head screwdriver (or similar tool)
and re-install the cheek padding and the edge gasket.
Fig. 18
Fig. 19
MCS III
13