Nolangroup N-Com MCS III R Serie Mode D'emploi page 11

ONLY FOR HELMET N100-5 – positioning of wiring and microphone
Positioning the left side wiring:
 Lift up the plastic lining of the cheek padding (Fig. 11).
Fix the cable inside the helmet and make sure the left fixing clip snaps into its housing (Fig. 12).

Reposition the plastic lining of the cheek padding, arranging it behind the two small stop hooks (Fig.

13).
Fig. 11
 Check that the connectors of the microphone and loudspeakers are correctly plugged in.
 Position the left and right speakers in the respective housing obtained in the polystyrene cheek
padding. If necessary, rotate the speakers slightly in their housing. If necessary, secure them using
the adhesive strips supplied as standard equipment.
Fig. 14
Fig. 12
 Reassemble the gasket and secure it with the
specific screw, making sure that the cable
connecting to the motorbike comes out of
the helmet as shown in Fig. 14.
 Reassemble the cheek padding.
MCS III
Fig. 13
11