Partyspace Casa Africa TIKI HUT Mode D'emploi page 19

TIKI HUT RONDE - MANUAL FR
19
Step 6: Place the roof cone along the outer
centre ridge of the f rame, if necessary with
the aid of a broomstick. For large models,
you can f irst place the roof cone on the
f rame and raise it to aff ix the last reed
panels.
To keep the cone in place, attach it to
the f rame with the ties provided for this
purpose.
Step 7 - INSTALLING THE OPTIONAL
CLOSURE PANEL: The brackets of the 4
sliding bolts of each panel are screwed to
the inner f ramework of the tiki. Install the
brackets for each panel at the same distance
so that the panel can be installed in any
opening at a later date. Aff ix the sliding bolt
bracket 2 to 3 mm higher on the door panel
than on the other pillars, so that the closure
panel does not touch the worktop and the
door can be opened when the closure panel
is installed. In all of the other openings, the
panels may rest on the worktops. Screw the
handle vertically into the centre of the panel
or at an angle on the crossbeam.
Tip: number each panel and each f rame in
case the brackets of the sliding bolts have
not been attached at exactly the same
distance.
THE HUTS MUST BE CHECKED REGULARLY: ARE THE BOLTS FIRMLY ATTACHED, ARE THE
FRAME AND THE FLOOR ATTACHMENTS IN GOOD CONDITION?