Publicité
Les langues disponibles
Les langues disponibles
FEATURES
• Ergonomic, comfort grip with reversible, variable speed trigger.
• Keyless 1/4" chuck makes changing bits easy.
• Upgraded variable speed trigger provides full feather control
• Short front gearcase for easy access into tight areas.
• Full cage gear system.
AIR SUPPLY
Tools of this class operate on a wide range of air pressures. It is
recommended that air pressure of these tools measures 90 PSI at the tool
while running free. Higher pressure and unclean air will shorten tool life
because of faster wear and may create a hazardous condition.
Water in the air line will cause damage to the tool. Drain the air tank
daily. Clean the air inlet filter screen on at least a weekly schedule. The
recommended hook-up procedure can be viewed in Figure 1.
The air inlet (Figure 2), used for connecting air supply, has standard 1/4" NPT
American Thread.
Line pressure should be increased to compensate for unusually long air
hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and fittings
should have the same inside dimensions.
Nipple
WARRANTY
Matco warrants this air tool for a period of 1 year to the consumer. We will
repair any MT Series air tool covered under this warranty which proves to
be defective in material or workmanship during the warranty period. In order
to have your tool repaired, return the tool to one of the Matco Authorized
Warranty Centers listed, freight prepaid. Please include a copy of your proof
of purchase and a brief description of the problem. The tool will be inspected
and if any part or parts are found to be defective in material or workmanship,
the tool will be repaired free of charge and returned to you freight prepaid.
This warranty gives you specific rights. You may also have other rights which
vary from state to state.
The foregoing obligation is Matco's sole liability under this or any implied
warranty and under no circumstances shall Matco be liable for any incidental
or consequential damages.
note: Some states do not allow the exclusion or limitation of incidental or
consequential damages so the above limitation or exclusion may not apply
to you.
MT1885
MT1885 1/4" Reversible Mini Air Drill
• General purpose drill is compact and lightweight.
• Bottom handle diffused exhaust.
TROUBLESHOOTING
Other factors outside the tool may cause loss of power or erratic action.
Reduced compressor output, excessive drain on the air line, moisture or
restrictions in air pipes or the use of hose connections of improper size or
poor conditions may reduce air supply. If outside conditions are in order,
disconnect tool from hose and take tool to your nearest Matco authorized
service center.
LUBRICATION & MAINTENANCE
Lubricate the air motor daily with quality air tool oil. If no air line oiler is used,
run a 1/2 ounce of oil through the tool. The oil can be squirted into the tool
air inlet or into the hose at the nearest con nec tion to the air supply, then run
the tool.
FIG. 1
MATCO AIR
COMMAND
Tool Repair SV
1330 Commerce Dr.
Stow, OH 44224
(800) 433-7098
DISCOUNT TOOL
REPAIR
3433 Losee Rd. #1
North Las Vegas, NV 89030
(702) 657-6570
3
SPEED
TRIGGER
FORWARD/REVERSE
LEVER
AIR INLET
PNEUTOOL PARTS &
SERVICES CO., LTD
33 Haas Road
Toronto
ON M9W 3A1 Canada
(416) 748-1200
(888) 748-1201 (Toll-Free in
Canada)
DIVERSIFIED POWER
INC.
90 Buttermill Avenue,
Vaughan, Ontario
L4K 3X7 Canada
Tel: 905-760-9077
Toll Free: 800-821-7975
Rev. 07/25/11
FIG. 2
Publicité
