Publicité
Step 2
Separate the EXTENSION SLIDES (II) from the
å
EXTENSION RAILS (HH) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (HH) to the SMALL RIGHT
å
END (C) and SMALL UPRIGHT (E). Use four GOLD 5/16"
FLAT HEAD SCREWS (QQQ).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL out to fi nd the
other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
Finished edge
Page 8
II
Push the black lever in and pull the SLIDE from the RAIL.
E
Open end
C
HH
412116
Remember:
Righty tighty.
Lefty loosey.
HH
Finished edge
HH
QQQ
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Open end
Publicité
