Publicité
Step 13
Carefully turn your unit over onto its front edges. Lay the
å
BACKS (EE and FF) over your unit.
Make equal margins along the bottom and both side
å
edges of the BACKS (EE and FF). Push on opposite
corners of your unit if needed to make it "square".
Fasten the BACK (EE and FF) to your unit using
å
the NAILS (RRR).
www.sauder.com/services
Edge without holes
FF
412116
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(33 used in this step)
Finished surface
EE
RRR
Page 19
Publicité
