EINHELL BG-HR 20 A Mode D'emploi page 6

Anleitung_BG_HR_20_A_SPK1:_
GB
Table of contents:
1. Scope of use
2. Safety information
3. Layout and items supplied
4. Installation
5. Operation
6. Technical data
7. Ordering spare parts
1. Scope of use
The automatic hose reel makes it easier to water
garden plants and to clean all sorts of objects in
gardens and yards. It prevents tangled and twisted
hose pipes and allows you to store the hose properly
and tidily at all times.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
2. Safety information:
After use, turn off the water and empty the hose.
This makes it easier to wind up the hose.
The hose should be used only in an ambient
temperature of +5°C to +40°C. Do not expose
the hose to direct sunlight. This could damage
the hose.
After use, the hose on the hose reel must be
disconnected from the water connection.
Protect the hose from heat, oil and sharp edges.
If the hose reel is not required, the hose should
always be wound up!
Suitable measures must be taken to keep the
equipment out of the reach of children.
Never direct a strong water jet at persons or
animals – risk of inquiry.
Use only original replacement parts.
To prevent damage in freezing conditions, the
hose must be emptied completely at
temperatures below +4°C. If possible, store the
device in a room at temperatures above +4°C.
The automatic hose reel is designed to be
connected only to water pipes with a maximum
operating pressure of 6 bar.
Use the spray nozzle to interrupt the water flow
only for a short time. Turn off the water tap after
use and open the spray nozzle in order not to
place the system under unnecessary strain.
6
13.11.2008 9:48 Uhr Seite 6
If you want to use electric pumps, home
waterworks or similar equipment, make sure that
these are sufficiently pressure-resistant before
you use the spray nozzle to interrupt the water
flow. Failure to do so may result in damage.
We cannot accept any liability for damage which
occurs due to excessive pressure in pumps and
home waterworks.
Under no circumstances should you open or
repair the equipment yourself, as some parts
inside the housing may cause serious injuries.
3. Layout and items supplied (Fig. 1/2):
1. Carry handle
2. Automatic hose reel
3. 20 m pull-out hose
4. Spray nozzle
5. 1.5 m connection hose
6. Hose coupling
7. Coupling fastener
8. Wall holder
9. Retaining pin
10. Tap connector for G water tap
11. 3x hexagon head screw
12. 3x washer
13. 2x fastening bolt
14. 5x 10 mm wall plug
Not shown: Stopper for pull-out hose
4. Assembly
Note:
Select a point of installation where you can
connect the connecting hose with the quick-lock
coupling to a water tap (home waterworks or
other hose pipe) without the connecting hose
being placed under any tension. The automatic
hose reel must not be connected to or operated
together with water pipes without a water tap or
stopcock.
Use only suitable fastening material. The
supplied plugs and screws are suitable for
concrete, natural stone with a dense structure,
solid bricks, solid lime-sand blocks, solid blocks
made of lightweight concrete, pore concrete (gas
concrete), solid gypsum panels, perforated high
blocks, perforated lime-sand blocks and hollow
blocks made of lightweight concrete.
Important. Make sure that there are no electric
cables or other installations (for example water
pipes) near the drill holes.
We recommend an installation height of
0.7 – 1.2 m.