Page 1
Notice d’utilisation 1. Introduction This user manual gathers products of our CS series, detailes hereunder: Cette notice d’utilisation regroupe les treuils Goliath de la gamme CS, soit les produits suivants : CS100 – PF63201 CS100MD – PF63202 CS100PS – PF63204 CS200 –...
Page 2
Goliath lifting winches – CS series Treuils de levage Goliath CS User manual Notice d’utilisation Important use information Recommandations importantes d’utilisation These winches have been designed for lifting application, therefore, all recommendations and safety instructions have to be carefully read and applied.
Page 3
Goliath lifting winches – CS series Treuils de levage Goliath CS User manual Notice d’utilisation 4. Equipment setting (wire rope or strap) Mise en place d’un équipement (câble/sangle) /!\ Do use only the wire rope diameters and quality communicated on the winch label.
Page 4
Goliath lifting winches – CS series Treuils de levage Goliath CS User manual Notice d’utilisation - Pose d’une sangle 4.3.2. Strap setting Position the strap’s buckle on the same axis as the drum’s hole. Insert the screw M6x30 inside the drum’s hole from the outside, so the strap is set, as shown on figure 6.
Page 5
Goliath lifting winches – CS series Treuils de levage Goliath CS User manual Notice d’utilisation 4.6. Wire rope or strap folding Enroulement du câble/de la sangle The equivalent of at least 2 rounds of wire rope or strap around the drum is necessary. It can be marked in order to know when the minimum amount of wire rope or strap is reached.
Page 6
Goliath lifting winches – CS series Treuils de levage Goliath CS User manual Notice d’utilisation Nos treuils sont livrés nus sans câble ni sangle. Le treuil est auto-freiné. Il est nécessaire de s’assurer du bon fonctionnement de l’appareil avant toute utilisation, notamment en réalisant un essai de mise en service selon les réglementations en vigueur localement.