Télécharger Imprimer la page

Tool it junon LCD 5/9 Mode D'emploi page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
LCD
5/9-9/13
MAINTENANCE
• Expiration date: No expiration date for this product but the state of the JUNON welding helmet must be checked before each use.
• The JUNON helmet must not fall down.
• Do not put any heavy tools/objects in or on the helmet in order not to damage the filter or the protective screens.
• The deterioration of the filter or its protective screen can reduce the vision field or the protection level. Replace the damaged parts.
• Do not use any tools or other sharp objects to remove any components of filter or helmet. Doing so may damage filter or helmet preventing proper function, possibly causing
injury or cancellation of the warranty.
• Clean the filter with a clean cotton or with a special rag for lens.
• Clean and change protective screens on a regular basis.
• Clean the inside and the outside of the helmet with a neutral disinfectant product.
• Do not use any solvent.
REPLACING THE EXTERNAL PROTECTIVE SCREEN
1
2
3
A
REPLACING THE INTERNAL PROTECTIVE SCREEN (10)
WARNING
• Use the welding helmet only for eye and face protection against harmful ultra violet and infrared radiation, sparks and spatter from welding.
• This product will not protect you against serious impact hazards such as, fragments of grinding wheels or abrasive discs, stones, or other grinding tools,
explosive devices or corrosive liquids (non exhaustive list). Appropriate protection must be used where these hazards exist.
• The hairband may cause allergies to sensitive people.
• The opto-electronic filter of the JUNON is not waterproof and will not work properly if it has been in contact with water.
• Application temperature of the filter is from -5°C to +55°C.
• Storage temperature of the JUNON are from -20°C to +70°C.
SYMPTOMS AND SOLUTIONS
The optoelectronic filter does not work
Filter stays dark after the weld arc is extinguished or when no arc is
present
Uncontrolled and sparkling switching:
The filter lightens and darkens when welding.
Side of the filter is lighter than the center of viewing area
EN
3
The outer protection screen (2) is removable by placing a finger under
the screen on (A) of the helmet (1).
When changing the screen, make sure that the protective film (3) has
been removed. This film must be removed only when the protection
screen is in position in the helmet.
The internal protection screen (10) is removable by sliding it down by
placing a finger on (A).
When changing the screen, make sure you remove the protective
screen (11)
1
2
Activate the solar charge by exposing the cell to the light between 20 to 30 minutes - Check
and change battery if necessary. (Low volume alarm)
Make sure that the potentiometer is on the «welding» position (5-9 / 9-13)
Check and clean detectors if needed.
Adjust sensitivity knob to the lower position. If the welding place is extremely bright, it is
recommended to reduce light level.
Check arc sensors are not blocked from direct access to the arc light. Adjust sensitivity know
to the higher position.
It is a natural fature of LCD's, this symptom is not dangerous for the eyes. However for a
maximum comfort, try to keep an view angle at around 90°
6

Publicité

loading

Ce manuel est également adapté pour:

Junon lcd 9/13