INSTALLATION GUIDE
Please read all information before installing the lamps and keep this sheet for future reference.
• These lamps are direct replacements for 54W/1150MMT5/G5/HF lamps.
• Risk of electronic shock - Suitable for damp locations.
• Any modi cations to this product will void the warranty.
IMPORTANT SAFETY INFORMATION:
DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.
THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS. IF LAMP DOES NOT LIGHT WHEN THE LUMINAIRE IS ENERGIZED, REMOVE LAMP FROM LUMINAIRE AND
CONTACT LAMP MANUFACTURER OR QUALIFIED ELECTRICIAN.
CAUTION RISK OF FIRE - IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING, FLICKERING, ETC.), IMMEDIATELY TURN OFF POWER, REMOVE
LAMP FROM LUMINAIRE AND CONTACT MANUFACTURER.
NOT SUITABLE FOR ENCLOSED LUMINAIRES.
NOT FOR EMERGENCY LIGHTING
This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or
communication equipment operating between 0.45-30MHz.
Lamps must be operated within an ambient xture temperature of -22
INSTALLATION INSTRUCTIONS
STEP 1.
Make Sure Power is OFF
STEP 4A.
label
Insert the Westinghouse LED
replacement lamp.
NOTE: Please insert lamp per
label direction (on lamp back)
to make sure the light-produc-
ing side of the LED tube is
facing downwards.
F and 133
o
STEP 2.
Remove the di user, lens
cover or louver (if provided).
Fluorescent lamps to be
replaced with Westinghouse
TLED T5 lamps are shown
above.
STEP 4B.
Then, rotate the lamp 90°
degrees.
Make sure that the pins are
completely seated in the
lamp holders. One LED
lamp for each uorescent
lamp removed.
2
F to ensure UL compliance.
o
STEP 3A.
Remove the uorescent lamp.
First, rotate the lamp 90°
degrees.
STEP 5.
Repeat steps 3 and 4 as
needed for additional lamps.
Replace the di user, lens
cover or louver (if removed in
step 2).
STEP 3B.
Then, remove the lamp from
the lamp holder.
STEP 6.
Power ON.
ESF-WH-039