Skil 1470 Notice Originale page 8

pointing downwards
- check the tight seating of the accessory (incorrect
8
pad C 2
! the dust suction requires the use of perforated
sanding sheets
! perforation in sanding sheet should correspond
with perforation in sanding foot
! replace worn sanding sheets in time
! always use the tool with the total VELCRO
surface covered with sanding paper
9
! do not use dust extraction device/vacuum cleaner
when sanding metal
position
! before the accessory reaches the workpiece, the
tool should run at full speed
! before switching off the tool, you should lift it
from the workpiece
0
- the optimal working speed depends on the material
and can be determined with practical trials
! while working, always hold the tool at the
grey-coloured grip area(s) !
2
standard included @
APPLICATION ADVICE
2
2
MAINTENANCE / SERVICE
2
! disconnect the plug before cleaning
power tools
- send the tool undismantled
ENVIRONMENT
Do not dispose of electric tools, accessories and
packaging together with household waste material
6
disposing occurs
2
NOISE/VIBRATION
✱
✱
✱
✱
increase
not
reduce
! protect yourself against the effects of vibration
by maintaining the tool and its accessories,
keeping your hands warm, and organizing your
work patterns
Outil multifonctions
INTRODUCTION
8
1470