Troubleshooting - Husky DPFWS Guide D'utilisation Et D'entretien

Troubleshooting

Problems Possible Cause(s)
Air leaking at trigger O-rings in trigger valve housing
valve area. are damaged.
Loose screws in housing.
Air leaking between
Damaged O-rings.
housing and nose.
Damaged bumper.
Air leaking between Loose screws.
housing and cap. Damaged gasket.
Worn bumper.
Tool skips driving
Dirt in nose piece.
fastener.
Dirt or damage prevent the fasteners
or pusher from moving freely in
magazine.
Damaged pusher spring.
Inadequate air flow to tool.
Worn O-ring on piston or lack of
lubrication.
Damaged O-ring on trigger valve.
Air leaks.
Cap seal leaking.
Tool runs slow or has Tool not lubricated sufficiently.
loss of power. Broken spring in cylinder cap.
Exhaust port in cap is blocked.
Guide on driver is worn.
Fasteners are
Fasteners are not correct size.
jammed in tool.
Fasteners are bent.
Magazine or nose screws are loose.
Drive blade is damaged.
Corrective Action
Replace O-rings.
Tighten screws.
Replace O-rings.
Replace bumper.
Tighten screws.
Replace gasket.
Replace bumper.
Clean drive channel.
Clean magazine.
Replace spring.
Checking fitting, hose, or compressor.
Replace and lubricate O-rings.
Replace O-rings.
Tighten screws and fittings.
Replace gasket.
Lubricate nailer.
Replace spring.
Replace damaged internal parts.
Replace guide.
Use only recommended fasteners.
Replace with undamaged fasteners.
Tighten screws.
Replace drive blade.
14
Question, problems, missing parts? Before returning to the store,
Call Husky Customer Service
8 a.m - 6 p.m, EST, Monday- Friday
1-888-HD-HUSKY
HUSKYTOOLS.COM
Retain this manual for future use.
15
Please contact 1-888-HD-HSUKY for further assistance.
HUSKYTOOLS .COM