Specifications; Features; Operation; Adjusting The Exhaust - Husky DPFWS Guide D'utilisation Et D'entretien

Specifications

Air consumption : 0.96 SCFM with 100 fasteners
per minute @ 80 psi
Air inlet: 1/4 inch NPT
Magazine capacity: 100 PCS
Weight: 2.06 lbs
Maximum pressure: 100 psi
Pressure range: 60 psi – 100 psi
Fasteners range: 1/4 inch to 9/16 inch

Features

360 ADJUSTABLE EXHAUST °
Allows user to direct air away from face.
COMFORT-GRIP HANDLE
For increased comfort and control .
ERGONOMICALLY ENGINEERED BODY
Rugged and comfortable resulting in a light-weight tool
great for extended use.
NON-MARRING SAFETY CONTACT
Eliminates damage to working surface.
ADJUSTABLE DEPTH
Depth is easily adjustable for various applications.
0.417"(10.6mm)
1/4" 6 m m
0.05"
5/16" 8 m m
( . 1 26 mm)
3/8" 10 m m
1/2" 12 m m
9/16"
14 m m
Compatible with all generic 20 gauge fine wire staples.
8

Operation

1

Adjusting the Exhaust

The adjustable exhaust on the cap of the tool allows
users to direct the exhaust according to operator
preference To adjust the direction turn the exhaust cap
.
in the desired direction
.
0.022"
( . 0 55 mm)
2

Loading fasteners

Connect the tool to the air source
Push down on the Latch Button (A) Pull back on the Inner
Magazine (B) .
Please load the fasteners with the head of the staples
facing the same direction as the work contact element
beneath the magazine. THIS TOOL IS A BOTTOM
LOADING STAPLER!
Push the Inner Magazine (B) forward until latch button
pops up
.
Inner Magazine(B)
WARNING: The tool may fire when it is first
connected to the air source. Always connect the
tool to the air source before loading fasteners to
prevent injury from unintended cycling. Always make
sure the tool's magazine is empty at the beginning
,
of each work session before connecting to an air
source.
WARNING: Keep the tool pointed away from yourself
and others when loading fasteners. Failure to do so
could result in possible serious personal injury.
WARNING: Use only those fasteners recommended
for use with this tool. Fasteners not identified for use
with this tool by the tool manufacturer are able to
result in a risk of injury to persons or tool damage
when used in this tool.
WARNING: Never load fasteners with the workpiece
contact or trigger activated. Doing so could result in
possible serious personal injury.
.
.
3

Unloading fasteners

Unloading is the reverse of loading, except always disconnect the air
source before unloading.
WARNING: Always unload all fasteners before
removing tool from service.
Latch button(A)
WARNING: Always disconnect the air source before
unloading.
4

Clearing jams

Occasionally, a fastener may become jammed in the firing
mechanism of the tool, making the tool inoperable. To
remove a jammed fastener, follow the steps below:
Disconnect the tool from the air source.
Remove fasteners from the tool. Failure to do so will
cause the fasteners to eject from the front of the tool.
Pull back the inner magazine (B) and remove the
jammed fastener from the nose (C).
Reconnect the tool to the air source
Reload the tool with fasteners
9
Please contact 1-888-HD-HUSKY for further assistance.
,
.
.
HUSKYTOOLS .COM