Before Operation - F.F. Group CHD Notice Originale

8 | English
Uncertain-
dB
ty K
Vibration total values a
and uncertainty K determined according to ΕΝ
62841-1, ΕΝ62841-2
Vibration level max:
a m/s
2
h
K m/s
2
Battery:
Type
Voltage V
Rating Ah
Charging
min
time (80%)
Charging
min
time (100%)
Charger:
Rated
V
Voltage
Rated Fre-
Hz
quency
Rated D.C.
Output V DC
Voltage
Rated D.C.
Output A
Current
IDENTIFICATION
1. Variable speed trigger switch
2. Forward/reverse switch
3. Keyless chuck
4a. Torque setting ring
4b. Hammer Rotary selector
5. Two speed selector
6. LED working light
7. Belt Clip
8. Battery pack release button
9. Battery pack
10. Battery Charger

BEFORE OPERATION

FITTING AND REMOVING THE BATTERY
Slide the battery into the handle until it engages. To
remove the battery, push the yellow battery release
button and pull the battery out of the handle.
CHECKING THE BATTERY STATUS (11)
The battery is equipped with a charge level indicator.
Use the battery charge status indicator to plan your
work and/or to avoid deep discharge.
To check the charge level, press the battery charge
ƒ
level indicator button.
The charge level is represented by red,yellow and
ƒ
green LEDs.
When the battery is fully charged all three LEDs light up.
ƒ
3
(triax vector sum)
h
3,054
1,5
Li-Ion
20
2,5 5,0
50 90
60 120
100-240
50/60
22
3,0
LED battery status indicator
Green LED on
Yellow LED on
Red LED on
CHARGING THE BATTERY
:
NOTE Before first using your cordless hammer
drill, please charge the battery first.
The charger is equipped with a LED charging indicator
lamp. During charging, the indicator light will light up
red. After completion of charging,the light turns green.
Connect the charger to a suitable mains socket. The
ƒ
green charging light comes on
Slide the battery onto the charger, the red charging
ƒ
light comes on
The charger may become warm and buzz slightly during
ƒ
charging. This is normal and does not indicate a fault.
OPERATION INSTRUCTIONS
FITTING TOOLS
Both drill bits and screwdriver bits can be fitted to
the chuck.
To open the chuck rotate the chuck (3) anti-clock-
ƒ
wise
Insert your tool and tighten the chuck by hand
ƒ
CHANGING SPEED (5)
To prevent the risk of damage to gears change
speeds only when the machine has come to a
complete stop.
The two speed selector controls the speed of the drill.
First gear allows slower drilling with more torque,while
second gear is suitable when less torque but higher
speed is required.
Slide the selector forward to select first gear.
Slide the selector backward to select second gear.
FORWARD/REVERSE SWITCH (2)
/ Shown on the forward/reverse lever
Set the Left/right switch to
1.
Change the direction of rotation only when the
2.
machine is not in operation!
VARIABLE SPEED
To start drilling squeeze the variable speed trigger.
To stop drilling release the trigger.
Note: The more the trigger is depressed, the fast-
er the drilling bit will rotate.
Caution: Operating the machine with a low speed
for a long time will increase the risk that the motor
will be overheated. To prevent overheating, let the
motor cool down regularly (Stop using the machine
for 15 minutes).
TORQUE SETTING (4a)
Rotate the torque setting ring to the desired setting.
The torque setting will help you regulate the driving
CHD/60-BL 20V PRO
Capacity
>100%
>67%
>30%
or