Télécharger Imprimer la page

Oase FiltoClear 12000 Notice D'emploi page 22

Masquer les pouces Voir aussi pour FiltoClear 12000:

Publicité

Les langues disponibles

Les langues disponibles

- EN -
OASE recommend:
– as a filter starter: OASE BioKick.
– as a reference value for the fish population in the pond: approx. 60 cm fish length in 1 m³ pond water.
– as a pond pump for FiltoClear 12000: Aquamax Eco 8000.
– as a pond pump for FiltoClear 16000: Aquamax Eco 10000.
– as a pond pump for FiltoClear 20000: Aquamax Eco 12000.
– as a pond pump for FiltoClear 30000: Aquamax Eco 16000.
Scope of delivery
Figure (B)
Quantity
1
1
20
2
21
2
22
1
23
1
24
1
25
1
26
3
27
1
28
2
29
4
Intended use
FiltoClear 12000/16000/20000/30000, referred to as "unit", may only be used as specified in the following:
• For mechanical and biological cleaning of garden ponds
• Operate in accordance with instructions.
The following restrictions apply to the unit:
• Never use the unit to filter fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation
 A
To be taken into consideration for planning:
– Spacing between unit and water: min. 2 m (safety spacing!).
– Do not expose the unit to direct sun radiation.
– Water return point. OASE recommend: Route the return hose such that the clean water is indirectly returned to
the pond, e.g. through a water course. In this manner it will be additionally enriched with oxygen.
– Height difference between filter lid and water return point: max. 2 m.
Installation possibility 1: Bury close to the pond.
Dig a hole close to the pond and place the container into the hole up to the mark (B 11).
Installation possibility 2: Placement close to the pond.
Place the unit close to the pond where it is flood protected (e.g. hidden behind shrubs). The ground must be firm and
level.
Connecting a filter pump
A filter pump is required to operate the pressure filter (only contained as a set in the scope of delivery). Only connect to
the pump by means of pressure hoses approved for at least 0.2 bar or the maximum pump pressure.
Hoses with an internal diameter of 1 1/2" or 2" can be connected to the unit.
22
Description
FiltoClear Pressure filter with UVC unit
Connection material
Hose connector, transparent, 2"
Hose connector, transparent, 1 ½"
Hose connector, black, 2"
Hose connector, black, 2", with thread
Hose connector, black, 1 ½"
Hose connector, black, 1 ½", with thread
Union nut
Flat sealing ring, black
Flow indicator flap, green
Hose clip

Publicité

loading

Ce manuel est également adapté pour:

Filtoclear 16000Filtoclear 20000Filtoclear 30000