Publicité
Les langues disponibles
Les langues disponibles
OE 0800
INDUCTION HEATER
NOTE: During heating there should be a gap of around 5-10mm between the coil and the heated
material to avoid excessive wear of the heating coil. A gap larger than 5-10mm decreases heating
efficiency and extends the heating time.
Holding of the coil directly on the hot material can cause the burning of the coil insulation,
thereby shortening the service life of the coils. We recommend limiting direct contact of the
coil with the hot material to the minimum.
ATTENTION: The coil and the heated object can reach a high temperature and/or cause burns
or result in fire.
NOTE: The service life of the coils can be increased by cleaning rust, paint, oil etc. from the
heated material
TIP! For loosening nuts, screws etc., it is not necessary to heat the material until it is red hot. Heat
the nut for 2 seconds and try to loosen it using a wrench. If it is not possible, heat again for 2
seconds and then try loosening using the wrench again.
Flexible coil
The flexible coil is used for the loosening of axle fitments, stiffened sensors, ball joints etc and in
applications where is not possible to use attachable coils.
Applications:
1. Connect one end of the coil to the coil holder and secure it by the locking screw.
2. Wrap the free end of the conductor over the part which needs to be heated. Make around 2-4
turns.
3. Connect the second - free end of the coil into the coil holder and secure it by the locking screw.
4. Pressing of the key activates the heating.
5. After finishing heating, one end of the coil will be release and the coil will be unwound from
the heated material.
If the overload of the device occurs (the LED warning light on the front panel is flashing red),
unwind one loop and repeat the procedure until the heating is carried out without overload and
turning off.
If the heating has a low intensity, on the contrary, try adding one loop.
Device indicators
Lights on the device indicate the following states of the device:
• Green = Standby
• Yellow = Heating in progress
• Yellow flashing = Device is overheated
• Red flashing = Bad coil or power overload
• Red light = Error
Publicité
