CLAS OE 0800 Mode D'emploi page 13

OE 0800
INDUCTION HEATER
ATTENTION: Coil applicator and heated object can reach high temperatures and cause burns or
cause a fire.
When using the device OE 0800 always wear safety goggles or face shield.
When using the device OE 0800 hazardous fumes may be produced by burning old paint,
lubricants, sealants, adhesives, etc. These exhalations can be toxic. Always wear appropriate
protective masks or respirators.
When working with the device OE 0800 always wear protective gloves with corresponding
thermal resistance. High temperatures generated by the use of OE 0800 may cause serious
burns in the case of touching the heated part.
Always keep proper footing and balance for safe control of the device even in unexpected
situations.
Do not use OE 0800 near the device with pyrotechnics (e.g. airbag). The resulting heat can
cause their unexpected explosion. Keep a minimum distance of 10-20 cm from these devices.
Eletrical safety rules
This is a safety class I device, which may be supplied with power only from the power outlet with
a protective conductor, which must be connected to the device as first and in any case must not
be interrupted (e.g. by an extension cord).
Any interruption of the protective earth conductor, or its disconnection will cause a potential
electric shock hazard that can cause injury.
Make sure that the device (device chassis) is properly grounded.
Do not twist or sharply bend the power cord, as it may damage the internal wiring.
Never use OE 0800 if the power cord shows any signs of damage.
Keep the power cord away from heat, oil, sharp edges or moving parts.
Never repair the power cord – if damaged, the power cord must be replaced. Damaged cords
create a risk of electric shock.
Before replacing the applicator (coil), disconnect OE 0800 from the power source (wall outlet).
If you are not using OE 0800, unplug the power cord from the outlet.
CAUTION
This product is for class A industrial use. It may cause radio interference in residential, commercial
and light industrial environments. This product is not intended for installation in residential
environment, business environment and light industry with connection to the public supply
network; user may be required to take adequate measures to reduce interference.