Publicité
Les langues disponibles
Les langues disponibles
OE 0800
INDUCTION HEATER
COMPONENTS
• PLastic case with protect lining
• Coil holder (1)
• Connection cord (2)
• Switch on and overheating indication
light (3)
• Coils (4)
• Electric supply cord
Before usage of the device, check the incoming cable, handle and the handle cable to assure
that they are not damaged.
1. Disconnect the device from the electric network and loosen the screws on the handle.
2. Insert the working coil into the holes in the clamping holder of the coils and tighten the
locking screws on the sides.
3. Connect the supply cable of the device into a properly grounded standard socket ~230V,
50/60Hz and turn on the device using the main switch. Before turning on, make sure that
the handle is laid in a safe place and that the heating button is not pressed down.
4. Attach or put the working coil on the material you want to warm up and press the button
on the handle. Heating remains activated during the pressing of the button - do not exceed
the operating cycle of 2 minutes of heating and 2 minutes of cooling.
5. After finishing the cycle, release the button on the handle and remove the heating coil
from the heated material.
6. After finishing heating, place the handle with the heating coil in a safe, inflammable place
until the heating coil is completely cooled. Then turn off the device using the main switch
and disconnect it from the electric network.
2
USE
4
3
1
Publicité
