Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
FIG.1
Attach the Legs (#4 and #5) to the Billiard Cabinet (#1) using four Bolts (#A46) and four
Washers (#A47) per Leg.
Attach the End Leg Brace (#6) to the Legs using four Bolts (#A46) and four Washers (#A47)
per End Leg Brace.
Pilot Holes
must be facing
down for correct
hook assembly.
Pilot Holes
on one side
End Apron.
HELPFUL HINT:
Be sure legs (#4 and #5) and leg brace (#6)
are all assembled together on the same side
of the table as shown.
Future assembly steps require holes on these
legs to be in a certain position for correct
assembly.
T-Nuts face
inside.
A46
A47
A47
T-Nuts face
inside.
NO Pilot Holes
on this side.
HELPFUL HINT:
A46
The main cabinet #1
must be in position
as shown in the
diagram with the
rivet plug hole close
to the left hand side
(near leg #4 as
shown in FIG 1).
Publicité
