EB TECHNOLOGY NOLOGO RX Mode D'emploi page 9

TRANSCEIVER
First Installation
Receiver
1
Put all DIP-SWITCHES in OFF position (Tx and Rx)
Give power Supply to the receiver 12/24 Ac/Dc, if 12 V make a link to
2
JUMPER 12V. LED-0 and LED-1 fl ashes fastly and the receiver make a "
beep" sound.
Cancel of the memory of the receiver
This operation should be done at the fi rst installation.
Cancel the memory of the receiver: keep pressed the P1 PROG
3
for 12 seconds, when the receiver sounds, release the button.
Transmitter
Connect to the terminal board the N.C. contact or the 8.2 K resistive edge
4
contact.
Select the input with DIP SWITCH 2 for Input 1 and DIP-SWITCH 3 for Input 2:
5
OFF: Select an input for a N.C. contact
ON: For a 8.2 K resistive edge contact
Give power supply on the TX with two 1,5V batteries LR06 AA:
6
LED-1 of the transmitter fl ashes fast and then slowly
Cancel of the memory of the trasmitter
This operation should be done at the fi rst installation.
7
Press and keep pressed both P1 and P2 of the transmietter
After 5 seconds the l.e.d. are lit on to indicate the cancellation of the memory.
8
Release the buttons.
The memory will be cancelled where test codes are previously memorized.
-9-
GB
TX
RX
1 1 2 2 3 3 4 4
12 V 24 V
> >
P1 PROG BUZZER P1 PROG
Ing. COSTA 1
7
8
COM coste
9
Ing. COSTA 2
ON
1 1 2 2 3 3 4 4
DIP 2-3 TX
ON 8K2 - OFF NC
led
TX1
+
P1 - TX P2 - TX
led
TX1