EB TECHNOLOGY NOLOGO RX Mode D'emploi page 10

GB
Memorization of TX and RX
Before starting the memorization, put dip-switch 4 of the tx as shown:
DIP 4 - TX
ON
OFF
Memorization IN 1
1 1 2 2 3 3 4 4
How to learn a code on OUT 1 (RX)
To associate one safety edge to the output OUT1 in the receiver do as follow:
1. Press once the P1 PROG of the receiver, LED TX1 fl ashes once.
2. Press P1 of the transmitter within 60 seconds after pressing P1-PROG.
3. If the buzzer beeps it means that the operation is confi rmed, if the TX is already memorized the buzzer
beeps three times.
4. Once the memorization has been fi nished , the receiver goes automaticall and the LED RX1 turns off.
If you need to memorize extra transmitters starts from point 1 again.
How to learn a code on OUT 2 (RX)
To associate one safety edge to the output OUT2 in the receiver do as follow:
1. Press twice the P1 PROG of the receiver, LED TX1 fl ashes once.
2. Press P1 of the transmitter within 60 seconds after pressing P1-PROG.
3. If the buzzer beeps it means that the operation is confi rmed, if the TX is already memorized the buzzer
beeps three times.
4. Once the memorization has been fi nished , the receiver goes automaticall and the LED RX1 turns off.
If you need to memorize extra transmitters starts from point 1 again.
IN. 1
NC
DIP 4 - TX
ON
ON
Memorization IN 2
1 1 2 2 3 3 4 4
IN. 2
-10-
TRANSCEIVER
NC