Operation - Hart HGHBL01VNM 20V Manuel D'utilisation

ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack or
unplug the power source from the product when
assembling parts.

OPERATION

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
This product is intended for blower use only and is not
designed for vacuum use. Do not attempt to remove
the main reducer housing that covers the impellers.
Removal of the main reducer housing will expose
the moving impellers and contact with these impeller
blades can result in serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
 Align the arrow on the upper blower tube with the arrow
on the blower housing and push tube on to the blower
housing outlet until it is completely seated on the housing.
 Align the arrow on the lower blower tube with the arrow
on the upper blower tube and push the lower tube onto
the upper tube until it is completely seated.
 To remove the blower tubes, slide tubes off.
WARNING:
Verify that all guards and tubes are in place prior to use.
If the blower is dropped, stop blower and verify that
no damage has occurred. If any guard, part, or tube
is damaged or missing, do not use blower until it has
been repaired or replaced by a qualified service center.
Use of blower with damaged or missing guards, parts,
or tubes can result in serious personal injury or further
damage to the blower.
NOTICE:
Before each use, inspect the entire product for dam-
aged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or an authorized service center for assistance.
8 – English