Operation - Hart HLVC01 40V Manuel D'utilisation

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Verify that all guards and tubes are in place prior to use.
If the vacuum is dropped, stop vacuum and verify that
no damage has occurred. If any guard, part, or tube is
damaged or missing, do not use vacuum until it has
been repaired or replaced by an authorized service
center. Use of vacuum with damaged or missing
guards, parts, or tubes can result in serious personal
injury or further damage to the vacuum.
NOTICE:
Before each use, inspect the entire product for
damaged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or an authorized service center for assistance.
APPLICATIONS
You may use this product for the purposes listed below:
 Clearing leaves and other debris from your lawn
 Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris
TO INSTALL/REMOVE BATTERY PACK
See Figure 6.
WARNING:
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
To install:
 Align the raised rib on the battery pack with groove in the
leaf vacuum's battery port and insert the battery pack into
the product as shown.
WARNING:
Make sure the latch on the battery pack snaps into
place and the battery pack is fully seated and secure in
the battery port before beginning operation. Failure to
securely seat the battery pack could cause the battery
pack to fall out, resulting in serious personal injury.
NOTICE:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the tool
and latches into place properly. Improper installation
of the battery pack can cause damage to internal
c omponents.
To remove:
 Locate the latch on the battery pack and depress to
release the battery pack from the leaf vacuum.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be in the OFF position
when not in use or carrying at your side. Remove
battery pack when transporting or carrying leaf vacuum
to avoid accidental starting, which could result in
serious injury.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
8 – English