F.F. Group MS 125 EASY Notice Originale page 5

MS 125 EASY
was designed.
Do not use the power tool if the switch
h
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be re-
paired.
Disconnect the plug from the power
h
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
Store idle power tools out of the reach
h
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
Maintain power tools. Check for misalign-
h
ment or binding of moving parts, break-
age of parts and any other condition that
may affect the power tool's operation. If
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean. Prop-
h
erly maintained cutting tools with sharp
cutting edges are less likely to bind and
are easier to control.
Use the power tool, accessories and tool
h
bits etc. in accordance with these instruc-
tions, taking into account the working
conditions and the work to be performed.
Use of the power tool for operations dif-
ferent from those intended could result in
a hazardous situation.
SERVICE
Have your power tool serviced by a qual-
ified repair person using only identical
replacement parts. This will ensure that
the safety of the power tool is maintained.
SAFETY INSTRUCTIONS FOR SANDERS
WARNING: Do not operate this tool un-
til it is completely assembled and
installed according to the instruc-
tions.
1. Hold your power tool by the insulated
gripping surfaces, especially when per-
forming an operation where the sanding
accessory could contact hidden wiring.
2. Protect your lungs. Wear a face or dust
mask during operation. Following this
rule will reduce the risk of serious respi-
ratory injury.
3. Protect your hearing. Wear hearing pro-
tection during extended periods of oper-
ation. Following this rule will reduce the
risk of serious personal injury.
4. Inspect power cords periodically and
repair them as needed at your nearest
authorized service center. Constantly stay
aware of cord location. Following this
rule will reduce the risk of electric shock
or fire.
5. Check damaged parts. Before further
use of the tool, determine that it will op-
erate properly and perform its intended
function. Check for alignment, binding
or breakage of moving parts or any other
conditions that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service center. Following
this rule will reduce the risk of shock, fire,
or serious injury.
6. Remove all nails from lumber before us-
ing this tool.
7. Do not use the sander to remove lead-
based paints.
WARNING: This product and the dust
created by power sanding, sawing,
grinding, drilling, and other con-
struction activities may contain
chemicals, including lead, can cause can-
cer, birth defects, or other reproductive
harm. Wash hands after handling. Some
examples of these chemicals are:
lead from lead-based paints
ƒ
crystalline silica from bricks and cement
ƒ
and other masonry products
arsenic and chromium from chemically
ƒ
treated lumber.
Use the machine only for dry sanding.
h
Penetration of water into the machine in-
creases the risk of an electric shock.
CAUTION, FIRE HAZARD! Avoid over-
heating the object being sanded as
well as the sander. Always empty
the dust collector before taking
English | 5
www.ffgroup-tools.com