F.F. Group CDD-BL 20V PRO Notice Originale page 8

8 | English
Hazardous Decomposition: None during normal op-
f
erating conditions. If cell is ruptured hydrogen flu-
oride and carbon monoxide may be released.
PRODUCT SPECIFICATIONS
INTENDED USE
The cordless drill is intended for drilling holes in
wood, plastic, metal etc and tightening or unscrew-
ing screws.
TECHNICAL DATA
Article number
Model
Drill Capacities:
Wood
Mild Steel
Maximum Torque
Revolutions Per Minute
(no load)
Chuck Capacity
Weight (drill & battery)
Sound emission values determined according
to EN 60745-1
Typically the A-weighted noise levels of the product
are:
Sound pressure level
Sound power level
Uncertainty K
Vibration total values a
and uncertainty K determined according to
EN 60745-1
Vibration level max:
a
h
K
Battery:
Type
Voltage
Rating
Charging time (80%)
Charging time (100%)
Charger:
Rated Voltage
Rated Frequency
Rated D.C. Output
Voltage
Rated D.C. Output
Current
41316
CDD BL 20V PRO
mm 35
mm 13
Nm 55
0-500
min
-1
0-1.700
mm 13
kg 1,5
dB(A) 77,5
dB(A) 88,5
dB 3
(triax vector sum)
h
m/s 2,04
2
m/s 1,5
2
Li-Ion
V 20
Ah 2,5
min 56
min 66
V 100-240
Hz 50/60
V DC 22
A 3,0
IDENTIFICATION
1. Variable speed trigger switch
2. Forward/reverse switch
3. Keyless chuck
4. Torque setting ring
5. Two speed selector
6. LED working light
7. Belt Clip
8. Battery pack release button
9. Battery pack
10. Battery Charger
BEFORE OPERATION
FITTING AND REMOVING THE BATTERY
Slide the battery into the handle until it engages. To
remove the battery, push the yellow battery release
button and pull the battery out of the handle.
CHECKING THE BATTERY STATUS (11)
The battery is equipped with a charge level indicator.
Use the battery charge status indicator to plan your
work and/or to avoid deep discharge.
To check the charge level, press the battery
ƒ
charge level indicator button.
The charge level is represented by red,yellow and
ƒ
green LEDs.
When the battery is fully charged all three LEDs light
ƒ
up.
LED battery status indicator
Green LED on
Yellow LED on
Red LED on
CHARGING THE BATTERY
:
NOTE Before first using your cordless drill,
please charge the battery first.
The charger is equipped with a LED charging indica-
tor lamp. During charging, the indicator light will light
up red. After completion of charging,the light turns
green.
Connect the charger to a suitable mains socket.
ƒ
The green charging light comes on
Slide the battery onto the charger, the red charging
ƒ
light comes on
The charger may become warm and buzz slightly
ƒ
during charging. This is normal and does not indicate
a fault.
OPERATION INSTRUCTIONS
FITTING TOOLS
Both drill bits and screwdriver bits can be fitted to
the chuck.
To open the chuck rotate the chuck (3) anti-clock-
ƒ
wise
Insert your tool and tighten the chuck by hand
ƒ
CHANGING SPEED (5)
To prevent the risk of damage to gears
change speeds only when the machine has
come to a complete stop.
CDD-BL 20V PRO
Capacity
>100%
>67%
>30%