Dogtra 1210NCP Serie Manuel Du Propriétaire page 32

CHARGING THE BATTERIES
Recharge the unit if :
The indicator light on the collar is emitting a red
color.
If the 3 bar indicator on the transmitter LCD
shows just 1 bar.
The indicator light on the transmitter or receiver
will not come on.
The indicator light on the transmitter or receiver
comes on momentarily, but will not stay on
when the "Constant" button is pushed.
Battery Charging Procedure
Note : The unit has a partial charge when it leaves
the Dogtra facility, upon receipt of the
collar, be sure to give it a full 2-hour initial
charge before the first use.
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on
page 59.
2. Plug the charger into a 120-volt wall outlet or,
if using the accessory field charger, plug into a
cigarette lighter only for Lithium-Polymer
battery. (Use a 230-volt European charger for
60
CHARGING THE BATTERIES
Europe.) When properly plugged in, all
indicator lights should glow red. During the
charging process, the unit will shut off. Once
the battery cable is unplugged from the unit
after a full charge, you will need to turn the
unit on again before use.
3. The Lithium-Polymer battery is fully charged
within 2 hours. The lights will stay red during
the charging process. The red light will change
into a steady green light when the battery is
fully charged. (When you disconnect the
charger after finishing the charge, you will
need to restart the units).
4. After charging, cover the battery charging
receptacles with the rubber plugs on the
transmitter and receiver.
NOTE : Only use Dogtra-approved batteries,
chargers, and accessories for your
Dogtra e-collars. When a charger is
not in use, disconnect it from the
power source.
61