Logitech G9x Mode D'emploi page 12

12
Custom-Color LED Display
Underneath the dpi adjust buttons, your G9x has an LED
display. The LEDs indicate both dpi and on-board memory
profile settings.
The G9x allows you to change the color of the LEDs to
your preference using SetPoint
favorite colors from a broad color spectrum. You can assign
a different color to each profile so you can always tell which
profile is enabled by the color of the LEDs.
LED Display Settings
LED settings will always be indicated in ascending order from left to right. The lighting scheme will
change depending on the number of dpi and profile settings you choose to have, but in all cases,
the LEDs will light up to indicate lowest setting on the left to highest setting on the right.
This LED display by default will indicate what dpi setting is active (DPI Mode). When the Profile button
(bottom of the mouse) is being pressed (Profile Mode), the LEDs will indicate which profile setting stored
in on-board memory is enabled. In this Profile Mode, the running man LED will blink to show you are able
to actively change the profile setting. When the mouse is in DPI mode, pressing the + and – buttons will
change dpi setting. When in Profile Mode, these same buttons will change the Profile setting.
Note: When Application Detection is enabled in SetPoint
profile settings.
English
® software. Choose your
, the LEDs will only indicate dpi settings and not
®