Electrolux ERX3313AOX Notice D'utilisation page 11

Problem
The compressor op-
erates continually.
The compressor
does not start im-
mediately after
pressing the Shop-
pingMode switch, or
after changing the
temperature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Upper or lower
square is shown in
the temperature dis-
play.
Possible cause
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
Shopping function switch-
ed on.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
ENGLISH
Solution
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Switch off Shopping man-
ually, or wait to set the tem-
perature until the function
has reset automatically. Re-
fer to ShoppingMode .
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
11