ubbink Robotclean3 Mode D'emploi page 5

1 Pool Robotclean 3 Operating Manual and Parts List
Attention: The pool cleaner must always be placed in or removed from the pool in such a way that the underside of the pool cleaner faces the pool wall to avoid possible scratches on
the pool or film surface.
The pool cleaner automatically changes direction as soon as it touches the pool wall (or rises up and down for pools with a curved bottom).
4. After the work cycle is complete, turn the cleaner off and gently pull the cable towards the pool wall. Use the handle (not the cable!!) to lift the device out of the water. Hold the
cleaner above the water for 10-15 seconds to allow the water to drain from the device.
Tips and advice
- The pool cleaner and the filter insert should be cleaned after each use.
- The pH-value of the pool water should be between 7.0 and 7.4.
- The water temperature should be between 10°C and 35°C.
Dealing with the problem
Fault
Cable twisted or winds up
Cleaner does not reach the entire pool area
Cleaner does not work
Cleaner does not climb the pool walls
Cleaning the waterline
The following steps are not required if the cleaner climbs the pool walls easily.
However, if it is difficult for the cleaner to climb the pool walls and clean the waterline, please use the two foam blocks included in the delivery, which give the cleaner an additional
buoyancy when climbing the pool walls.
- Open both sides of the top cover
- Remove the adhesive protection films and stick one foam block on both
inner sides of the cover. See illustration.
Manual RobotClean 3 2020.indd 3 Manual RobotClean 3 2020.indd 3
Cause
Pool shape or circular cleaning pattern
Obstruction in the pool
Long working time
Power supply unit positioned incorrectly
Algae on the pool bottom
Customised pool shape
Pool filter system is switched on
Cable in the pool not long enough
Power cable not connected properly
Blocked
Electrical fault
Filter baskets soiled
Wheels are worn
Climbing height
Solution
Untangle the cable
Remove the obstruction in the pool
Untangle the cable
Place the power supply unit in the correct position so that
the cleaner can reach the entire area
Remove algae from the bottom and walls of the pool
Place the cleaner in the position that needs special cleaning
Switch the pool filter system off
Release as much cable as possible into the pool
Check the power supply and the cable connections
Check the impeller or drive system
Contact your salesperson
Clean the filter baskets
Replace the wheels
Fix float blocks to the cleaner
26.10.20 12:20 26.10.20 12:20